Pond Building Series
Ideal for Ponds up to 900 gallons
Features:
- Energy efficient hybrid motor
- Includes flow control
- Fish and plant safe
- 15 Foot Cord
Maximum Pumping Height: 8 ft / 2.5 m
Specifications
Powerful multi-function capability, including: fountain nozzles, water features and filtration
600 GPH Pro Grade Pond Pump Specifications
| Output Connection |
1″ – 3/4″ |
| Cord Length |
15 ft / 5 m |
| Power Supply |
120v 60Hz .35A |
| Power Consumption |
37 watts |
| Flow Rate |
600 GPH / 2400 LPH |
| Stop Height |
96 inches / 250 cm |
| Approved |
CUL |
Pump Care – Pumps should always be plugged into a grounded GFCI receptacle.
Pumps should always be fully submersed in water. Low water levels may cause burnout, voiding your warranty.
We recommended that you run the pump in a bucket of water first, to “prime the pump” and insure proper operation. The power cord should extend or hang lower than the wall plug socket; this is to prevent water drops from making contact with the plug or electrical supply outlet. These pumps should be cleaned regularly to insure long life. Hard water buildup on impeller will cause reduced efficiency. The diagram below shows proper disassembly procedures.
Winter Care – We Strongly Suggest Storage in areas with Harsh Winter Conditions!
These units are designed for outdoor use during the spring, summer, and fall months. The unit should be stored properly in areas with harsh winter conditions, with all water removed, preferably in shelter. The pump must be drained of all water.
CAUTION: This Pump Has Been Evaluated For Use With Water Only
600 GPH Pro Grade Pond Pump Instructions
This entry was posted
on Friday, April 23rd, 2010 at 1:33 pm and is filed under Circulate, Pond, Pro-Grade.
You can follow any responses to this entry through the RSS 2.0 feed.
You can skip to the end and leave a response. Pinging is currently not allowed.
