Assembly
Experiencing a problem with water flow?
View this video to learn more. In some installations, improper placement of your pump can cause the tubing to bend, or “kink”, preventing proper water flow for the desired effect of the unit.
Simply insuring that the pump is set in its reservoir area properly, and checking to be sure the tubing is “kink free”, is enough to solve this issue.
However, it is possible that your tubing is slightly too long, causing the kinking.
We strive to include the exact length of tubing required to operate your fountain with no adjustment required.
However, as this is a hand made product, there may be some slight trimming necessary to ensure your water flow achieves the intended result.
A simple trim to the length of tubing of even an inch can do wonders for proper water flow.
Remember to measure twice and cut once! Use scissors or a sharp exacto-knife for best results.
video
View more about:
#1 Water Flow Solution
Posted in Assembly, Technical Support, Troubleshooting, Videos, Water Flow | No Comments »
Experiencing a problem with water flow?
View this video to learn more. To prevent water from escaping through the fountain cord pipe we have included this part. This black rubber cord cap cover is easy to install. Watch this video to see how.
video
View more about:
How-To: Install A ‘Cord Pipe Cover’
Posted in Assembly, Frequently Asked Questions, How to, Technical Support | No Comments »
|
This fountain comes with our innovative splash reduction system. If splash is a concern, simply drape the splash line over each spill point to dramatically reduce splash.
|
Here you can see the spill is creating a large amount of splash. |
Simply place one end of the ‘splash line’ in the top bowl and hang the other end off the bowl. |
The water will now run down the line and greatly reduce amount splash. |
View more about:
How-To: Install Splash Line
Posted in Assembly, Frequently Asked Questions, How to, Technical Support, Water Flow | No Comments »
Some of our fountains and statuary use a slip fit system to secure all parts into place. If you’re product uses this system, you will find a small piece of PVC pipe located inside the packaging. Use the PVC pipe as illustrated below to securely connect the parts together.
View more about:
Slip Fit System
Posted in Assembly, How to, Technical Support | No Comments »
View this video to learn more.Some of our more “technical” fountains may require a few more steps in assembly. View this video for helpful information on properly installing a cord pipe cover and light accessory for the Yoshi fountain.
View more about:
Yoshi Assembly Tips
Posted in Assembly, How to, Lighting and Accessories, Technical Support, Troubleshooting, Videos | No Comments »
You are currently browsing the archives for the Assembly category.
