Angelo D&233;cor
Suitable for fountains
and water features
requiring up to
55″ (140cm) of water lift.
Features:
- Energy Efficient
- Low Operating Costs
- Oil Free
- Adjustable Flow Control
- 16 Foot Cord
Specifications
No Data
300 GPH Fountain Specifications
| Output Connection |
1/2″ – 3/4″ |
| Cord Length |
16 ft / 5 m |
| Power Supply |
120v 60 Hz |
| Power Consumption |
30 watts |
| Flow Rate |
300 GPH / 1200 LPH |
| Stop Height |
78 inches / 200 cm |
| Dimension LxWxH(mm) |
90x58x72 |
| Approved |
CUL |
Intended Use – We recommend this unit for outdoor use.
This fountain is designed for outdoor use. While it can be used indoors, there will be moisture generated in the surrounding area. Therefore, care should be taken to use only in areas where water will not cause damage to hardwood floors, carpet, etc. It should also not be used indoors in areas of frequent foot traffic, as the moisture will cause slippery floor surfaces.
Pump Care – Pumps should always be plugged into a grounded GFCI receptacle.
Pumps should always be fully submersed in water. Low water levels may cause burnout, voiding your warranty.
We recommended that you run the pump in a bucket of water first, to “prime the pump” and insure proper operation. The power cord should extend or hang lower than the wall plug socket; this is to prevent water drops from making contact with the plug or electrical supply outlet. These pumps should be cleaned regularly to insure long life. Hard water buildup on impeller will cause reduced efficiency. The diagram below shows proper disassembly procedures.
Winter Care – We Strongly Suggest Storage in areas with Harsh Winter Conditions!
These units are designed for outdoor use during the spring, summer, and fall months. The unit should be stored properly in areas with harsh winter conditions, with all water removed, preferably in shelter. The pump must be drained of all water.
Maintenance – Keep it Clean!
Your fountain will work better, and last longer, when kept clean using a soft cloth and mild soap on a regular basis. At minimum, you should change the water with a blast from your hose, and keep leaves and debris out of the unit. Hard water should be avoided if possible, to reduce staining and paint discoloration. Small chips or minor paint erosion can easily be fixed using commonly available “hobby paints” that are close to the existing finish.
WARNING: To reduce the risk of electrical shock, use only on portable self-contained fountains no larger than 5 feet in any dimension.
CAUTION: This Pump Has Been Evaluated For Use With Water Only
300 GPH Fountain Pump Assembly
