Pond Building Series
Ideal for Ponds up to 300 gallons
Includes:
- 200 GPH energy efficient pump
- Pre-Filter
- Output, Adapter, and Flow Diverter
- Telescoping Extension tube
- 3 Fountain Nozzles: Tiered, Bell, and Trumpet
- 10 Foot Cord
Maximum Pumping Height: 5.5 ft / 1.7 m
Specifications
Compatible with our:
- Pond Filter Box 600
AD46400
- Spouting Statues
- Pond Liner Sizes Up To: 7×10 ft
200 GPH Pond Pump with Fountain Nozzles Specifications
| Cord Length |
10 ft / 3 m |
| Power Supply |
120v 60Hz .25A |
| Power Consumption |
15.5 watts |
| Flow Rate |
200 GPH / 800 LPH |
| Stop Height |
5.5 ft / 170 cm |
| Approved |
CUL |
Pump Care – Pumps should always be plugged into a grounded GFCI receptacle.
Pumps should always be fully submersed in water. Low water levels may cause burnout, voiding your warranty.
We recommended that you run the pump in a bucket of water first, to “prime the pump” and insure proper operation. The power cord should extend or hang lower than the wall plug socket; this is to prevent water drops from making contact with the plug or electrical supply outlet. These pumps should be cleaned regularly to insure long life. Hard water buildup on impeller will cause reduced efficiency. The diagram below shows proper disassembly procedures.
Winter Care – We Strongly Suggest Storage in areas with Harsh Winter Conditions!
These units are designed for outdoor use during the spring, summer, and fall months. The unit should be stored properly in areas with harsh winter conditions, with all water removed, preferably in shelter. The pump must be drained of all water.
CAUTION: This Pump Has Been Evaluated For Use With Water Only
200 GPH Pond Pump with Fountain Nozzles Instructions English
200 GPH Pond Pump with Fountain Nozzles Instructions French
